HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 27
3 - ENABLE-MODE COMMANDS
CHAPTER 3 Enable-Mode Commands
In This Chapter This chapter is a reference for enable-mode commands. Enable-mode commands are
commands that display process information.
To enter enable-mode 1. Connect to the CLI. For detailed information, see “Connecting to the CLI” on
page 19.
2. To enter enable-mode, at the system prompt enter:
host > enable
host #
To enter enable-mode, enter enable. For information about the enable command, see
“enable” on page 23.
To exit enable-mode, enter exit. For information about the exit command, see “exit”
on page 23.
This chapter describes the following enable-mode commands:
 “configure terminal,” next
 “debug generate dump” on page 30
 “disable” on page 30
 “file debug-dump” on page 30
 “file stats” on page 31
 “reload” on page 31
 “restart” on page 32
 “show aaa” on page 32
 “show arp” on page 32
 “show bootvar” on page 32
 “show cli” on page 33
 “show clock” on page 33
 “show configuration” on page 33
 “show configuration files” on page 34