HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 83
4 - CONFIGURATION-MODE
C
OMMANDS
Parameters
Usage For example, on the new appliance:
datastore receive port 7600
On the existing appliance:
Usage
datastore send addr <primary IP address of new appliance> port 7600
Example minna (config) # datastore send addr 10.0.0.03
minna (config) #
datastore sync enable
Description Enables automatic data store synchronization. The data store is replicated from the
master (primary) HP EFS WAN Accelerator to the backup (passive) HP EFS WAN
Accelerator in failover configurations. The no command option disables data store
synchronization.
IMPORTANT: If you are setting up automated data store synchronization for the first time, the
HP EFS WAN Accelerator service is halted on the backup HP EFS WAN Accelerator. You must
restart the HP EFS WAN Accelerator service on both HP EFS WAN Accelerators.
Syntax datastore sync enable
Parameters None
Example
minna (config) # datastore sync enable
minna (config) #
datastore sync peer-ip
Description Sets the IP address for the peer HP EFS WAN Accelerator for which you want to
replicate data on.
Syntax datastore sync peer-ip <addr>
Parameters
Example
minna (config) # datastore sync peer-ip 10.0.0.3
minna (config) #
<addr> Specifies the IP address of the remote HP EFS WAN Accelerator.
<port> Specifies the port of the remote HP EFS WAN Accelerator.
<addr> Specifies the IP address of the peer HP EFS WAN Accelerator.