HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 93
4 - CONFIGURATION-MODE
C
OMMANDS
For detailed information about how to configure an HP EFS WAN Accelerator for PBR
with CDP, see the HP StorageWorks Enterprise File Services WAN Accelerator
Deployment Guide.
Syntax in-path cdp enable
Parameters None
Example
minna (config) # in-path cdp enable
minna (config) #
in-path cdp holdtime
Description Configures the hold-time for CDP. This refresh period allows for a quick recovery in
failover deployments with PBR and CDP. The no command option disables the CDP
hold-time.
CDP is proprietary protocol used by Cisco routers and switches to obtain neighbor IP
addresses, model, IOS version, and so forth. The protocol runs at the Open System
Interconnection (OSI) layer 2 using the 802.3 Ethernet frame.
For detailed information about how to configure an HP EFS WAN Accelerator for PBR
with CDP, see the HP StorageWorks Enterprise File Services WAN Accelerator
Deployment Guide.
Syntax in-path cdp holdtime <holdtime>
Parameters
Example
minna (config) # in-path cdp holdtime 10
minna (config) #
in-path cdp interval
Description Configures the refresh period for CDP. This refresh period allows for a quick
recovery in failover deployments with PBR and CDP. The no command option
disables the CDP refresh period.
CDP is proprietary protocol used by Cisco routers and switches to obtain neighbor IP
addresses, model, IOS version, and so forth. The protocol runs at the Open System
Interconnection (OSI) layer 2 using the 802.3 Ethernet frame.
For detailed information about how to configure an HP EFS WAN Accelerator for PBR
with CDP, see the HP StorageWorks Enterprise File Services WAN Accelerator
Deployment Guide.
Syntax in-path cdp interval <interval>
<holdtime> Specifies the CDP hold-time in seconds. The default value is 5.