HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

94 4 - CONFIGURATION-MODE COMMANDS
Parameters
Example
minna (config) # in-path cdp holdtime 10
minna (config) #
in-path enable
Description Enables in-path support. An in-path configuration is a configuration in which the HP
EFS WAN Accelerator is in the direct path of the client and the server. The no
command option disables in-path support.
Syntax in-path enable
Parameters None
Example
minna (config) # in-path enable
minna (config) #
in-path interface enable
Description Enables the in-path interface for optimization. The in-path interface enable
command is useful only when there are multiple bypass cards enabled (for example,
with a Four-Port Copper Gigabit-Ethernet Bypass card). The no command option
disables the in-path interface.
Syntax in-path interface <interface> enable
Parameters
Example
minna (config) #in-path interface 10.0.0.1 enable
minna (config) #
in-path interface vlan tag
Description Enables Virtual Local Area Network (VLAN) support for an in-path HP EFS WAN
Accelerator on a trunked link. The in-path interface vlan tag command enables you
to set which VLAN to use when the HP EFS WAN Accelerator communicates with
another HP EFS WAN Accelerator. It does not define which VLAN to optimize. To
define which VLAN to optimize, you must define in-path rules and apply them to all
VLANS or a specific VLAN. The no command option disables the VLAN support.
Syntax in-path interface <interface> vlan tag <id>
<interval> Specifies the CDP interval in seconds. The default value is 1.
<interface> Specifies the IP address of the in-path interface.