HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Management Console user guide (AG421-96002, March 2007)

52 CONFIGURING THE HP EFS WAN ACCELERATOR
Setting Host Parameters
This section describes how to set host parameters for the HP EFS WAN Accelerator.
It includes the following sections:
 “Setting the Primary Interface,” next
 “Setting In-Path Interfaces” on page 54
 “Setting Auxiliary Interfaces” on page 58
 “Setting Main Static Routes” on page 59
 “Setting Static In-Path Routes” on page 60
 “Setting the DNS” on page 61
 “Modifying the Host Name” on page 63
 “Mapping Hosts to IP Addresses” on page 63
 “Setting Proxies” on page 64
Setting the
Primary
Interface
You modify settings for the primary interface in the Host Settings - Interface Primary
page.
You were prompted to configure the primary interface when you completed the
installation wizard. This section describes how you can modify these settings.
IMPORTANT: The primary and in-path interfaces can share the same subnet. The primary and
auxiliary interfaces cannot share the same network subnet.