DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 113
53-1001775-01
Editing the EMC call home center
4
14. Enter a password in the SMTP Server Settings - Password field.
This is a required field when the SMTP server authentication is enabled.
15. Enter the e-mail address for replies in the E-mail Notification Settings - Reply Address field.
16. Enter the customer e-mail address in the E-mail Notification Settings - Send To Address field.
17. Click Send Test to test the mail server.
The selected call home center must be enabled to test the mail server.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
18. Click OK.
The Call Home Configuration dialog box displays with the call home center you edited
highlighted in the Call Home Centers table.
19. Click OK to close the Call Home Configuration dialog box.
Editing the EMC call home center
To edit an EMC call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the EMC call home center you want to edit in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
The Configure Call Home Center dialog box displays (Figure 52).
FIGURE 52 Configure Call Home Center dialog box (EMC option)
4. Make sure the EMC call home center type displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Set the time interval at which to check the call home center by selecting the Set the heartbeat
interval at ___ days (1-28) check box and entering the interval in the field.