DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 305

53-1001775-01

Configuring a fabric mode Top Talker monitor

NOTE

A fabric mode Top Talker and an end-to-end monitor cannot be configured on the same fabric. You

must delete the end-to-end monitor before you configure the fabric mode Top Talker.

NOTE

A fabric mode Top Talker and an F_port mode Top Talker cannot be configured on the same fabric.

You must delete the F_port mode Top Talker before you configure the fabric mode Top Talker.

To configure a fabric mode Top Talker monitor, complete the following steps.

1. Select the device or fabric on which you want to monitor Top Talker data.

NOTE

On the 24 - 8 Gbps FC Port, 8 - 10 Gbps CEE Port Switch, Top Talkers is only supported on the

8Gbps FC Ports.

2. Select Monitor > Performance > Top Talkers.

The Top talker Selector dialog box displays.

FIGURE 114 Top talker Selector dialog box

3. Select Fabric to select a switch to monitor in the Top Talker Mode list.

You can only select one device on which to enable Top Talker.

4. Click OK on the Top talker Selector dialog box.

Top Talker is enabled on the selected device. The Top Talkers - Fabric Mode for Device_Name

dialog box displays.

The Top Talkers - Fabric Mode for Device_Name dialog box displays.