DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 333
53-1001775-01
Adding a Link threshold
13
Adding a Link threshold
NOTE
This threshold is only available for M-EOS devices.
To add Link thresholds, complete the following steps.
1. Select Configure > Port Fencing.
The Port Fencing dialog box displays.
2. Select Link from the Violation Type list.
3. Click Add.
The Add Link Threshold dialog box displays (Figure 128).
FIGURE 128 Add Link Threshold dialog box
4. Enter a name for the threshold in the Name field.
5. Select the number of link errors allowed for the threshold from the Threshold errors list.
6. Select the time period for the threshold (in minutes) from the errors per list.
7. Clic k OK to add the Link threshold to the table and close the Add Link Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 339.
8. Click OK on the Port Fencing dialog box.