DCFM Enterprise User Manual (53-1001775-01, June 2010)

336 DCFM Enterprise User Manual
53-1001775-01
Adding a State Change threshold
13
c. Select the time period for the threshold from the errors per list. The following choices are
available:
• None—the port is blocked as soon as the specified number of protocol errors allowed
is met.
• Second—the port is blocked as soon as the specified number of protocol errors
allowed is reached within a second.
• Minute—the port is blocked as soon as the specified number of protocol errors allowed
is reached within a minute.
• Hour—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a hour.
• Day—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a day.
7. Clic k OK to add the protocol errors threshold to the table and close the Add Protocol Error
Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 339.
8. Click OK on the Port Fencing dialog box.
Adding a State Change threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
To add an State Change threshold, complete the following steps.
1. Select Configure > Port Fencing.
The Port Fencing dialog box displays (Figure 124).
FIGURE 131 Port Fencing dialog box