DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 341
53-1001775-01
Editing an Invalid CRCs threshold
13
FIGURE 133 Edit C3 Discard Frames Threshold dialog box
4. Change the name for the threshold in the Name field, if necessary.
5. Select one of the following options:
• Default—Uses device defaults. Go to step 8.
• Custom—Uses your selections. Continue with step 6.
6. Change the number of discarded frames allowed for the threshold in the Threshold field, if
necessary.
7. Change the time period for the threshold from the errors per list, if necessary.
8. Click OK on the Edit C3 Discard Frames Threshold dialog box.
If the threshold has already been assigned to ports, an “Are you sure you want to make the
requested changes to this threshold on “X” ports?” message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 339.
9. Click OK on the Port Fencing dialog box.
Editing an Invalid CRCs threshold
NOTE
This threshold is only available for Fabric OS devices.
To edit an Invalid CRCs threshold, complete the following steps.
1. Select Configure > Port Fencing.
The Port Fencing dialog box displays.
2. Select Invalid CRCs (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
The Edit Invalid CRCs Threshold dialog box displays.
FIGURE 134 Edit Invalid CRCs Threshold dialog box