DCFM Enterprise User Manual (53-1001775-01, June 2010)

420 DCFM Enterprise User Manual

53-1001775-01

Opening the CEE Configuration dialog box

1. Launch the CEE Configuration dialog box using one of the following methods:

• Select Configure > Switch > CEE from the menu bar.

• Right-click the CEE switch from the device tree, and select Configure > CEE.

• Right-click the CEE switch from the topology map and select Configure > CEE.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

NOTE

The Protocol Down Reason column displays only if the 10 Gbps CEE/FC switch module is

selected.

FIGURE 172 CEE configuration dialog box

2. Select the CEE switch, link aggregation group, or CEE port to perform one of the following

converged enhanced Ethernet tasks, which are detailed later in this chapter.

• “Adding a LAG” on page 427

• “Deleting a LAG” on page 434

• “Editing a LAG” on page 432

• “Enabling a CEE port or LAG” on page 434