Manualshelf

DCFM Enterprise User Manual (53-1001775-01, June 2010)

ManualsBrandsHP ManualsStorageHP StorageWorks Edge Switch 2/12
461462463464465466467468469470
424 DCFM Enterprise User Manual
53-1001775-01
Minimum CEE configuration for FCoE traffic
17
Configuring the CEE interface with the CEE Map and Global LLDP profile
To configure the CEE interface, complete the following steps.
1. Select Configure > Switch > CEE.
The CEE Configuration dialog box displays.
2. Select the Te port connected to the CNA in the CEE Ports and LAGs table and click Edit.
3. Select the Port tab, if necessary, and select the Enable check box.
4. Select L2 from the Interface Mode list.
5. Select Converged (for Brocade CNA) or the Access (for QLogic CNA) from the L2 Mode list.
6. Click the QOS tab and select the Assign a map to Te Port Number check box.
7. Sele ct CEE from the Map Type list.
8. Select the CEE map you created in “Creating a CEE map to carry the LAN and SAN traffic” on
page 422 from the Available CEE Maps list.
9. Click the LLDP-DCBX tab and select the Enable LLDP-DCBX on Te Port Number check box.
10. Select Assign the Global Configuration.
11. Click OK.
The CEE Confirmation and Status dialog box displays.
12. Click Start on the CEE Confirmation and Status dialog box to save the changes to the switch.
13. Click Close on the CEE Configuration dialog box.
Create the FCoE VLAN to carry FCoE traffic
NOTE
This procedure is completed using Web Tools. For more information, see “CEE switch management
using Web Tools” on page 463.
To create the FCoE VLAN, complete the following steps.
1. Select the Brocade FCoE switch in the Product Tree or Connectivity Map.
2. Select Configure > Element Manager > Admin.
Web Tools displays. You can also launch Web Tools by clicking the Element Manager button on
the CEE Configuration dialog box.
3. Click the CEE tab.
4. Click the VLAN tab.
5. Click Add.
The VLAN Configuration dialog box displays.
6. Enter the VLAN identifier in the VLAN ID field.
7. Clic k OK on the VLAN Configuration dialog box.
The VLAN Configuration dialog box displays.
8. Select the VLAN you created and click Edit to convert the VLAN to FCoE VLAN.