DCFM Enterprise User Manual (53-1001775-01, June 2010)

546 DCFM Enterprise User Manual
53-1001775-01
Adding encryption targets
20
6. Select the encryption engine (blade or switch) you want to configure, and click Next.
The Select Target panel displays. This panel lists all target ports and target nodes in the same
fabric as the encryption engine. The Select Target list does not show targets that are already
configured in an encryption group.
There are two available methods for selecting targets: select from the list of known targets or
manually enter the port and node WWNs.
FIGURE 238 Select Target dialog box
a. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
the target information that displays using the nsshow command.) You can also enter
WWNs manually if you prefer, or if you want to specify a target that is not on the list.
b. Select a Target Type. If the target node is disk storage, choose Disk. If the target node is
tape storage, choose Tape.