DCFM Enterprise User Manual (53-1001775-01, June 2010)

578 DCFM Enterprise User Manual

53-1001775-01

Enabling the encryption engine state from Properties

To enable the encryption engine, complete the following steps.

1. Find the Set State To entry under Encryption Engine Properties.

2. Click the field and select Enabled.

3. Click OK.

Disabling the encryption engine state from Properties

To disable the encryption engine, complete the following steps.

1. Find the Set State To entry under Encryption Engine Properties.

2. Click the field and select Disabled.

3. Click OK.

Viewing and editing group properties

To view encryption group properties, complete the following steps.

1. Select Configure > Encryption.

The Encryption Center dialog box displays.

2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu

bar.

The encryption groups display in the Encryption Devices table.

3. Select a group from the Encryption Devices table, and select Group > Properties from the

menu bar, or right-click the group and select Properties.

The Encryption Group Properties dialog box, shown in Figure 257, has six tabs which are

defined in this section:

• “General tab” on page 579

• “Members tab” on page 580

• “Security tab” on page 583

• “HA Clusters tab” on page 584

• “Engine Operations tab” on page 584

• “Link Keys tab” on page 585

• “Tape Pools tab” on page 585

NOTE

The Link Keys tab appears only if the key vault type is NetApp LKM.