DCFM Enterprise User Manual (53-1001775-01, June 2010)

630 DCFM Enterprise User Manual
53-1001775-01
Creating a new member in an LSAN zone
22
4. Select one or more LSAN zones to which you want to add members in the Zones list. (Press
SHIFT or CTRL and click each zone name to select more than one zone.)
5. Select one or more members to add to the zone in the Potential Members list. (Press SHIFT or
CTRL and click each member to select more than one member.
6. Click the right arrow between the Potential Members list and Zones list to add the selected
members to the zone.
A message may display informing you that one or some of the selected potential members
cannot be zoned. Click OK to close the message box. Reconsider your selections and make
corrections as appropriate.
7. Clic k Activate.
The Activate LSAN Zones dialog box displays.
8. Review the information in this dialog box.
9. Click OK to activate the LSAN zones.
A message box displays informing you that the zones you change will be saved in the zone
database and asking whether you want to proceed. Click Yes to confirm the activation, or No to
cancel the activation.
When you click Yes, a busy window displays indicating the activation is in progress. A status
field informs you whether the activation succeeded or failed. When it succeeds, icons for the
active zone configuration and its zones display green. When it fails, the message includes the
reason for the failure.
10. Click OK to continue.
All LSAN zones are activated on the selected fabrics and saved to the Zone DB.
11. Click OK to close the dialog box.
Creating a new member in an LSAN zone
Use this procedure to add a member to an LSAN zone when the member is not listed in the
Potential Members list of the Zone DB tab.
For instructions to add a member to a zone when the member is listed in the Potential Members
list, refer to the procedure Adding members to the LSAN zone” on page 629.
1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
The Zone DB tab of the Zoning dialog box displays.
3. Select one or more zones to which you want to add members in the Zones list. (Press SHIFT or
CTRL and click each zone name to select more than one zone.)
4. Click New Member.
The Add Zone Member dialog box displays.