DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 37

53-1001775-01

Discovering fabrics

2. Click Add Fabric to specify the IP addresses of the devices you want to discover.

The Address Properties dialog box displays.

FIGURE 19 Address Properties dialog box (IP Address tab)

3. Enter a name for the fabric in the Fabric Name field.

4. Enter an IP address for a device in the IP Address field.

For seed switch requirements, refer to “Seed switch requirements” on page 54.

NOTE

The Backbone Chassis cannot be used as a seed switch.

For M-EOS devices, the Management application accepts IP addresses in IPv4 and IPv6

formats. The IPv4 format is valid when the Operating System has IPv4 mode only or dual stack

mode. The IPv6 format is valid when the Operating System has IPv6 mode only or dual stack

mode.

If the firmware version is between M-EOS 9.6.X and 9.9.2, only the domain ID, WWN, and

topology are obtained for fabric members. To manage other fabric members, you must enter

specific IP addresses in the Discover Setup dialog box.

For Admin Domain (AD) discovery, Fabric OS switch must have Physical AD visibility.

For Virtual Fabric discovery device requirements, refer to “Virtual Fabrics requirements” on

page 590.

To discover a Virtual Fabric device, you must have the following permissions:

• Switch user account with Chassis Admin role permission on the physical chassis.

• Switch and SNMP v3 user account with access rights to all logical switches (all Fabric IDs

(1 - 128).

For information about configuring permissions on a Fabric OS device, refer to the

Fabric OS Administrator’s Guide.:

5. (Fabric OS devices only) Enter the user ID and password for the switch in the User ID and

Password fields.