DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 39
53-1001775-01
Configuring SNMP credentials
2
14. If you are configuring a 256-port director, select the Configure for 256-Port_Director_Name
check box.
• If you selected Configure for 256-Port_Director_Name, go to step 18.
• If you did not select Configure for 256-Port_Director_Name, continue with step 15.
FIGURE 21 Address Properties dialog box (SNMP Tab - v3)
15. Enter a user name in the User Name field.
16. Enter a context name In the Context Name field.
17. Select the authorization protocol in the Auth Protocol field.
18. Enter the authorization password in the Auth Password field.
• If you selected Configure for 256-Port_Director_Name, go to step 21.
• If you did not select Configure for 256-Port_Director_Name, continue with step 19.
19. Select the privacy protocol in the Priv Protocol field.
20. Enter the privacy password in the Priv Password field.
21. Click OK on the Address Properties dialog box.
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
22. Repeat step 2 through step 21 for each fabric you want to discover.
23. Click OK on the Discover Setup dialog box.
Configuring SNMP credentials
1. Select Discover > Setup.
The Discover Setup dialog box displays.
2. Select an IP address from the Available Addresses table.
3. Click Edit.
The Address Properties dialog box displays.
4. Click the SNMP tab.