DCFM Professional Plus User Manual (53-1001774-01, June 2010)

DCFM Professional Plus User Manual 355
53-1001774-01
15
CEE configuration tasks
The CEE Configuration dialog box enables you to perform the following tasks:
• Edit CEE ports for a selected switch. You can also add a link aggregation group (LAG) if a single
switch is selected.
• Edit a switch or port and configure the following CEE policies:
NOTE
Access Control List and Spanning Tree Protocol can also be set at the LAG level.
• QoS
• LLDP-DCBX
• Access Control List
• Spanning Tree Protocol
• 802.1x
• Enable or disable a LAG or CEE port.
• Display performance statistics for CEE ports.
Instructions for performing the CEE configuration tasks shown in Figure 106 are detailed in the
following sections:
• “Link aggregation groups” on page 362
• “QoS configuration” on page 373
• “LLDP-DCBX configuration” on page 382
• “Access Control List configuration” on page 388
• “Spanning Tree Protocol configuration” on page 393
• “802.1x authentication” on page 398
Minimum CEE configuration for FCoE traffic
You must complete the following proceudres to to create the basic configuration of CEE for FCoE
traffic.
NOTE
The first two procedures in this section can be completed as a single procedure. They were broken
into two separate procedures for clarity.