DCFM Professional Plus User Manual (53-1001774-01, June 2010)

DCFM Professional Plus User Manual 369

53-1001774-01

NOTE

If the primary or secondary IP address already exists on another interface, an error message

displays in the Status area.

Enabling a CEE port or LAG

If you select multiple switches or multiple ports and LAGs from two or more switches, both the

Enable button and the Disable button are disabled.

1. Select Configure > Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select one or more CEE ports or LAGs (which can span multiple switches) that you want to

enable.

NOTE

All selected LAGs must be in the same state (enabled or disabled); otherwise, both the Enable

and Disable buttons are disabled.

3. Click Enable.

The selected CEE port or LAG is enabled for CEE configuration.

4. Click OK.

The CEE Confirmation and Status dialog box displays.

5. Review the changes carefully before you accept them.

6. Click Start to apply the changes, or click Close to abort the operation.

The selected CEE port or LAG is enabled for CEE configuration. (The Status column in the CEE

Configuration dialog reflects the change).