Manualshelf

DCFM Professional Plus User Manual (53-1001774-01, June 2010)

ManualsBrandsHP ManualsStorageHP StorageWorks Edge Switch 2/12
591592593594595596597598599600
DCFM Professional Plus User Manual 561
53-1001774-01
19
7. (Optional) Perform the following steps to assign the ports to a logical switch other than the
default logical switch:
a. Select the destination logical switch in the Existing Logical Switches table.
b. Click the right arrow button.
The ports display in the selected logical switch node in the Existing Logical Switches table.
8. Click OK on the Logical Switches dialog box.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
NOTE
Ports are disabled before moving from one logical switch to another.
9. Select the Re-Enable ports after moving them check box.
10. (Optional) Select the Unbind Port Addresses while moving them check box.
11. Click Start to send these changes to the affected chassis.
NOTE
Most changes to logical switches will disrupt data traffic in the fabric.
The status of each change is displayed in the Status column and Status area in the dialog box.
12. When the changes are complete, click Close.
Deleting a logical switch
1. Select a switch on the Product List or Connectivity Map and select Configure > Logical
Switches.
The Logical Switches dialog box displays.
2. Right-click anywhere in the Existing Logical Switches table and select Table > Expand All.
3. Select the logical switch you want to delete from the Existing Logical Switches table and click
Delete.
All ports in the deleted logical switch are reassigned to the default logical switch.
4. Read the confirmation message and click Yes.
5. Click OK on the Logical Switches dialog box.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
NOTE
Ports are disabled before moving from one logical switch to another.
6. Select the Re-Enable ports after moving them check box.
7. (Optional) Select the Unbind Port Addresses while moving them check box.
8. Click Start to send these changes to the affected chassis.