Fabric OS Encryption Administrator's Guide v6.4.0 (53-1001864-01, June 2010)

80 Fabric OS Encryption Administrator’s Guide
53-1001864-01
Viewing and editing group properties
2
Enabling the encryption engine state from Properties
To enable the encryption engine, complete the following steps.
1. Find the Set State To entry under Encryption Engine Properties.
2. Click the field and select Enabled.
3. Click OK.
Disabling the encryption engine state from Properties
To disable the encryption engine, complete the following steps.
1. Find the Set State To entry under Encryption Engine Properties.
2. Click the field and select Disabled.
3. Click OK.
Viewing and editing group properties
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption.
The Encryption Center dialog box displays.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
bar.
The encryption groups display in the Encryption Devices table.
3. Select a group from the Encryption Devices table, and select Group > Properties from the
menu bar, or right-click the group and select Properties.
The Encryption Group Properties dialog box, shown in Figure 46, has six tabs which are defined
in this section:
• “General tab” on page 81
• “Members tab” on page 82
• “Security tab” on page 85
• “HA Clusters tab” on page 86
• “Engine Operations tab” on page 86
• “Tape Pools tab” on page 87
NOTE
The Link Keys tab appears only if the key vault type is NetApp LKM.