FW V06.02.00/HAFM SW V08.02.00 HP StorageWorks Edge Switch Release Notes (AA-RTDZF-TE, September 2004)
Table Of Contents
- Edge Switch release notes
- About this document
- Release notes information
- Intended audience
- Firmware version 06.02.00-22
- Other edge switch documentation
- CD-ROM directory structure
- Supported configurations
- Cable requirements
- Important information
- HAFM and firmware compatibility
- Prerequisites for installing and using firmware 06.02.00
- Upgrading from an earlier version of firmware
- Upgrading firmware on an edge switch from 04.xx.xx to 05.xx.xx
- Considerations for downgrading the version of firmware
- HAFM upgrade required for firmware version 06.xx.xx
- Second-generation switch support
- OSMS change
- Default zone is disabled by default
- Some IP addresses must be avoided
- Hard zoning
- Zoning change RSCN control
- SNMP changes
- Zoning limitations
- Using the same firmware
- Reinstalling feature licenses
- Disconnecting the null modem cable
- CTP controls port lights
- Ethernet switch support
- Full Volatility
- CLI threshold alerts
- CLI show.eventLog command
- MIHPTO value
- Route management-Preferred Path
- EWS enhancements
- Full-fabric capability for Edge Switch 2/12
- Hard zoning for Edge Switch 2/12 and Edge Switch 2/24 switch loop ports
- Known issues
- Certain unauthorized devices may increase response time for fabric operations under specific conditions with the Edge Switch 2/24
- HSG80 transparent mode not supported with IBM AIX
- HSG80 transparent mode not recommended with controller in SCSI-3 mode with HP-UX operating systems
- ISL disconnect causes NOS error with the OpenVMS operating systems
- Support for speed Auto-Negotiate
- Ports may accumulate spurious events
- Possible switch reset after power failure or power off sequence
- Deleting a certain switch binding member using EWS may cause an error
- SNMP issues
About this document
20 HP StorageWorks Edge Switch release notes
Full-fabric capability for Edge Switch 2/12
Unlike other edge switch and director products, a product feature enablement
(PFE) key, controls Edge Switch 2/12 E_Port-to-E_Port connections. Once the
feature key is purchased and installed, the switch can be configured for E_Port
connections on any of the active ports.
The feature key includes distance support. With firmware 06.00.00 and later, the
Edge Switch 2/12 ships standard with five buffer-to-buffer (BB) credits allocated
to each port. After activation of the Full Fabric feature on a switch, every port has
12 BB Credits allocated to support up to 12 km links at 2Gb/s speeds.
Hard zoning for Edge Switch 2/12 and Edge Switch 2/24 switch loop ports
Firmware 06.00.00 and later extends Hard Zoning to loop (FL) ports on Edge
Switch 2/12 and Edge Switch 2/24. Previously, zoning on FL ports was regulated
in software.