fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide

Configuring the Switch
130 Edge Switch 2/24 Product Manager User Guide
Modify an Alert
Use the following steps to modify an existing threshold alert configuration.
1. Select Threshold Alerts from the Configure menu.
The Configure Threshold Alerts dialog box displays.
2. Select the alert that you want to modify by clicking the alert information in the
table.
3. If the alert is active, select Deactivate, then select the alert information in the
table again.
4. Select Modify.
Note: If the alert is active, an error message displays prompting you to deactivate the
alert.
An initial Modify Threshold screen appears where you can change the
threshold type.
5. Select a threshold type from the drop-down list.
6. Select Next when you are done. A Modify Threshold screen appears where
you can change the % utilization, cumulative minutes for the threshold to
occur before notification, and the time interval for measuring throughput and
for alert notification.
7. Continue through the Modify Threshold screens until the summary screen
appears displaying the alert configuration.
8. Perform either of the following steps:
— If you need to change any parameters, select Previous and Next to
display the desired Modify Threshold screen.
— Select Finish when you are done.