FW 08.01.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-330, November 2005)

4-48
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Repair Information
2. Set the switch offline. For instructions, refer to Set Online State.
3. At the SAN management application’s physical map, right-
click the product icon representing the switch for which a
configuration file is to be reset to factory default settings, then
select Element Manager from the pop-up menu. The application
opens.
4. At the Element Manager application (management server), select
Reset Configuration from the Maintenance menu. The Reset
Configuration dialog box displays (Figure 4-20).
Figure 4-20 Reset Configuration Dialog Box
5. Click Reset to initiate the reset operation and close the dialog box.
6. The switch IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default address, the switch-to-management server
Ethernet link is not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default address, the switch-to-management server
Ethernet link drops and server communication is lost.
Continue to the next step.
7. To change the switch IP address and restart the management
server session, go to step 8. To restart a management server
session using the default IP address of 10.1.1.10:
a. Close the Element Manager application and return to the SAN
management application.
b. A grey square with a yellow exclamation mark appears
adjacent to the icon representing the reset switch, indicating
switch is not communicating with the management server.