FW V06.02.00/HAFM SW V08.02.00 HP StorageWorks Edge Switch Release Notes (AA-RTDZF-TE, September 2004)
Table Of Contents
- Edge Switch release notes
- About this document
- Release notes information
- Intended audience
- Firmware version 06.02.00-22
- Other edge switch documentation
- CD-ROM directory structure
- Supported configurations
- Cable requirements
- Important information
- HAFM and firmware compatibility
- Prerequisites for installing and using firmware 06.02.00
- Upgrading from an earlier version of firmware
- Upgrading firmware on an edge switch from 04.xx.xx to 05.xx.xx
- Considerations for downgrading the version of firmware
- HAFM upgrade required for firmware version 06.xx.xx
- Second-generation switch support
- OSMS change
- Default zone is disabled by default
- Some IP addresses must be avoided
- Hard zoning
- Zoning change RSCN control
- SNMP changes
- Zoning limitations
- Using the same firmware
- Reinstalling feature licenses
- Disconnecting the null modem cable
- CTP controls port lights
- Ethernet switch support
- Full Volatility
- CLI threshold alerts
- CLI show.eventLog command
- MIHPTO value
- Route management-Preferred Path
- EWS enhancements
- Full-fabric capability for Edge Switch 2/12
- Hard zoning for Edge Switch 2/12 and Edge Switch 2/24 switch loop ports
- Known issues
- Certain unauthorized devices may increase response time for fabric operations under specific conditions with the Edge Switch 2/24
- HSG80 transparent mode not supported with IBM AIX
- HSG80 transparent mode not recommended with controller in SCSI-3 mode with HP-UX operating systems
- ISL disconnect causes NOS error with the OpenVMS operating systems
- Support for speed Auto-Negotiate
- Ports may accumulate spurious events
- Possible switch reset after power failure or power off sequence
- Deleting a certain switch binding member using EWS may cause an error
- SNMP issues
About this document
9HP StorageWorks Edge Switch release notes
Prerequisites for installing and using firmware 06.02.00
If you are using HAFM, firmware 06.02.00 requires HAFM 07.01.00 or later
(check with HP Customer Support for the latest shipping version of HAFM).
HAFM should be at the minimum level before installing the new firmware.
Note: HAFM is not required for operating hardware products using the firmware.
All directors and edge switches in the same fabric should have the same firmware
level installed. Although products may co-exist in a fabric running different levels
of firmware, all products must be at the same major functional release level.
Upgrading from an earlier version of firmware
Upgrading to firmware 06.02.00-22 is non-disruptive to attached devices. The
director or edge switch is not required to be offline before performing an upgrade
operation. Limitations to upgrades are clearly identified if there are any
limitations to performing the operation.
05.02.00-13 07.01.00-09 (Notebook Server)
05.02.00-13 07.02.00-09 (HAFM Appliance)
05.05.00-12 None (Edge Switch 2/12)
06.01.00-18 07.01.00-09 (Notebook Server)
06.01.00-18 07.02.00-09 (HAFM Appliance)
06.01.00-18 08.02.00 recommended (HAFM
Appliance)
06.02.00-22 07.01.00-09 (Notebook Server)
06.02.00-22 07.02.00-09 (HAFM Appliance)
06.02.00-22 08.02.00 recommended (HAFM
Appliance)
Table 1: HAFM and firmware compatibility (Continued)
Firmware version HAFM version (minimum)