edge switch 2/32 product manager user guide

3–14 edge switch 2/32 product manager user guide
Configuring the Switch
Procedure (S/390 mode)
To configure ports in S/390 mode, use the following steps:
1. Choose Ports from the Configuration menu on the menu bar.
The Configure Ports dialog box displays.
Figure 3–5: Configure Ports dialog box (S/390 Mode)
Ports are numbered from 0 through 15.
2. Enable or disable extended distance buffering for the port by clicking the check
box in the 10-100 km column. When a check mark displays, extended distance
buffering is enabled.
3. Enable or disable LIN alerts for the port by clicking the check box in the LIN
Alerts column. When a check mark displays, LIN alerts are enabled.
NOTE: The factory default for LIN alerts is enabled.