edge switch 2/32 product manager user guide

edge switch 2/32 product manager user guide A–13
Product Manager Messages
Port binding was removed
from attached devices that
are also participating in
Switch Binding.
Informational message.
User has removed Port
Binding from attached
devices, but one or more of
these devices is still
controlled by Fabric Binding.
Review the Switch Binding
Membership List to
determine if the devices
should be members.
Port cannot swap to itself. Port addresses entered in
the Swap Ports dialog box
are the same.
Make sure that address in
the first and second port
address fields are different.
Port diagnostics cannot be
performed on an inactive
port.
This displays when port
diagnostics is run on a port
in an inactive state.
Run the diagnostics on an
active port.
Port speeds cannot be
configured at a higher rate
than the director/switch
speed.
This displays when you
configure a port to 2 GB/sec
and the Switch speed is set
to 1 Gb/sec.
Set the port speed to 1
Gb/sec in the Configure
Ports dialog box.
Product Manager error
<number>.
The Switch Product
Manager encountered an
internal error and cannot
continue.
Report the problem to
support personnel.
Product Manager instance is
currently open.
A Product Manager window
is currently open.
Informational message only.
R_A_TOV must be greater
than E_D_TOV.
R_A_TOV must be greater
than E_D_TOV.
Change one of the values so
that R_A_TOV is greater
than E_D_TOV.
Resource is unavailable. The specified operation
cannot be performed
because the product is
unavailable.
Verify that the HAFM
server-to-product link is up.
If the link is up, the HAFM
server may be busy. Try the
operation again later.
Send firmware failed. Send firmware operation
has failed.
Retry the operation. If the
condition persists, contact
support personnel.
SNMP trap address not
defined.
An SNMP trap address must
be defined if a community
name is defined.
Define an SNMP address.
Table A–1: StorageWorks Edge Switch 2/32 Product Manager Messages (Continued)
Message Description Action