edge switch 2/32 product manager user guide

A–14 edge switch 2/32 product manager user guide
Product Manager Messages
Stop diagnostics failed. The
test is already running.
Diagnostics for the port was
not running and Stop was
selected on the Port
Diagnostics dialog box.
Diagnostics quit for the port
for some reason, but the
Stop button remains
enabled.
Verify port operation. Retry
diagnostics for port and
choose Stop from the dialog
box. If problem persists,
contact your service
representative.
Stop diagnostics failed. The
test was not running.
The action to stop
diagnostics failed because
the test was not running.
Informational message.
Switch Binding was
removed from attached
devices that are also
participating in Port Binding.
Please review the Port
Binding Configuration.
The device WWNs were
removed from the Director's
Switch Membership List
(SANtegrity Switch Binding
feature), but you should note
that one or more of these
devices still has security
control in port binding.
Verify that the security level
for each device is as
required by reviewing the
Bound WWN list in the
Configure Ports dialog box.
Switch clock alert mode
must be cleared before
enabling period
synchronization.
Clock alert mode is enabled
through the Configure
FICON Management
Server dialog box and user
is attempting to enable
Periodic Date/Time
Synchronization through
the Configure Date and
Time dialog box.
Disable clock alert mode
through the Configure
FICON Management
Server dialog box.
System diagnostics cannot
run. The Operational Status
is invalid.
System diagnostics cannot
run on Switches with failed
ports.
Replace failed ports.
The add firmware process
has been aborted.
User has ended the add
firmware process.
N/A. An informational
message.
The data collection process
failed.
An error occurred in the data
collection process.
Contact support personnel.
Table A–1: StorageWorks Edge Switch 2/32 Product Manager Messages (Continued)
Message Description Action