edge switch 2/32 product manager user guide

1–10 edge switch 2/32 product manager user guide
Product Manager Overview
• Configure LIN alerts.
• Configure Port Binding.
• Configure port addresses (S/390 mode only)
• Configure Nickname to display instead of WWN for the Switch and attached
devices.
• Configure SNMP trap recipients and community names.
• Configure the FICON and Open Systems Management Server Features (if
installed)
• Configure the Switch name, location, description, and contact person.
• Control individual Fibre Channel ports by blocking/unblocking operation,
enabling LIN alerts and port binding, setting data speeds, and running internal and
external loopback diagnostics.
• Display FRU properties such as the FRU name, physical position in the Switch
(chassis slot number), active failed state, part number, and serial number.
• Display information for individual Fibre Channel ports, such as the port name,
port number, Fibre Channel address, operational state, type of port, and login data.
• Display information on nodes attached to ports.
• Display port performance and statistics.
• Display vital product data for the Switch, such as the system name, description,
contact person, location, status, model number, firmware and EC level, and
manufacturer.
• Enable beaconing for ports and the Switch unit.
• Enable channel wrap mode (S/390 mode only).
• Maintain a port address library (S/390 mode only).
• Monitor the operational status of the Switch and each of its hardware
field-replaceable units.
• Perform an initial program load (IPL).
• Perform maintenance tasks for the Switch including maintaining firmware levels,
administering the call-home feature, accessing the Switch logs, and collecting
data to support failure analysis.
• Reset port operation.
• Run port diagnostics.