edge switch 2/32 product manager user guide

2–12 edge switch 2/32 product manager user guide
Monitoring and Managing the Switch
• Build fabric protocol error.
• No principal switch (no switch in the fabric is capable of being principal
switch).
• No response from an attached switch.
Inactive Messages:
Optics speed conflict. An inactive state will occur if you set the port’s data speed
to 2 Gb/sec for a 2 Gb/sec port module, and then replace the port module with a
1 Gb/sec module. To activate the port in this case, replace the module with a
module that supports 2 Gb/sec data speed.
Displaying Switch Information
Double-click the Switch illustration, away from a hardware component, to display the
Switch Properties dialog box as shown in the following figure.
Figure 2–4: Switch Properties dialog box
The following displays in this dialog box:
• Switch name, description, location, and contact configured through the Configure
Identification dialog box
• Fibre Channel World Wide Name (WWN) identifier for the Switch
• Product type number