Fabric Watch Administrator's Guide v6.4.0 (53-1001770-01, June 2010)

52 Fabric Watch Administrator’s Guide
53-1001770-01
Customizing thConfig command settings
6
Customizing thConfig command settings
Perform the following steps to customize thConfig settings. Refer to the Fabric OS Command
Reference Manual for more information.
1. Connect to the switch and log in as admin.
2. Enter the thconfig command to display the list of operands.
switch:admin > thconfig
thconfig
--show [<class_name>] [-area <area_type>]
[-current]|[-thresh_level|-action_level <thresh_action>]
thconfig
--set <class_name> -area <area>
[-timebase <day:hour:minute:second:none>]
[-highth -value <val> -trigger above|below
-action [snmp],[raslog],[portlog],[email]|none]
[-lowth -value <val> -trigger above|below
-action [snmp],[raslog],[portlog],[email]|none]
[-buffer <val>]
[-nosave]
thconfig
--apply [<class_name> -area <area_type> -thresh_level <thresh_level>
-action_level <action_level>
thconfig
--cancel [<class_name> -area <area_type> -thresh_level <thresh_level>
-action_level <action_level>
thconfig
--show [<class_name>][-area_only]
Applying the configuration changes
Using the nosave command
The nosave command prevents the configuration changes from being saved persistently. This
option allows you to make and view changes without overwriting the saved configuration.
thConfig command restriction
The Fabric and Security classes are not supported in Access Gateway mode.
EE (End-to-end
Performance)
RXF - Receive areas
TXP - Transmit areas
Default or
Custom
1
Default or
Custom
2
It is recommended that you leave the
entire Performance Monitor Class and
End-to-End Performance Monitor
Class area settings in their default
state (no alerts).
1
To change the default, provide an integer value.
2
Valid custom action setting values include snmp, raslog, portlog, email, or none.
TABLE 12 Configuration options for thConfig command (Continued)
Class name Valid area types Threshold Threshold
action
Configuration recommendation