958-000290-003, March 2005)

Edge Switch 2/32 installation guide 27

5 Rear bracket (short)–not used in this configuration

Figure 6 Brackets included in kit

Required tools

The following tools are required, but are not included in the kit:

• Torque driver with a T10 Torx bit

• #2 Phillips screwdriver

Mounting the adjustable brackets in the rack

Use these steps to install the adjustable brackets on the rack. You will need a #2 Phillips screwdriver

and eight 10x32 panhead screws to complete this procedure.

NOTE: If you are installing the Edge Switch 2/32 in an HP 9000, 10000 or 11000 series rack,

you will need eight square alignment washers to complete this procedure.

1. Determine the position of the switch in the rack. Each Edge Switch 2/32 is 1.75 inches or 1U

high.