958-000290-003, March 2005)

Installing and configuring the Edge Switch 2/3254

Configure, enable, and test e-mail notification

Perform this procedure to configure, enable, and test e-mail and simple mail transfer protocol

(SMTP) addresses to receive notification of switch (and other product) events. Configure and test

procedures are performed at the HAFM appliance. E-mail notification is enabled for each switch at

the HAFM application.

To configure, enable, and test e-mail server addresses:

1. Minimize the Hardware View and return to the HAFM application.

2. At the HAFM application or EWS main window, select Monitor > Event Notification > Email. The

Email Event Notification Setup dialog box is displayed (Figure 26).

Figure 26 Configure Email dialog box

3. Enter the IP address or DNS host name of the SMTP server in the E-mail Server field. Use 64 or

fewer alphanumeric characters. HP recommends using the IP address.

4. Enter the e-mail address to which e-mail replies should be sent in the Reply Address field.

5. At the Summary Interval field, enter the length of time the application should wait between

notifications. Select seconds, minutes, or hours from the associated drop-down list.