958-000290-003, March 2005)

Installing and configuring the Edge Switch 2/3256

15.At the Hardware View, select Maintenance > Enable E-Mail Notification. A check mark is

displayed in the check box to indicate e-mail notification for the switch is enabled, and the menu

closes.

NOTE: Using HAFM, enable or disable e-mail event notification for each switch

individually.

Configure and enable call-home features

There are two call-home features available, and only one is installed when the HAFM application is

installed on the HAFM appliance. To learn more about configuring call-home features, refer to the

HP StorageWorks HA-Fabric Manager Appliance installation guide.

Configure and enable ethernet events

Perform this procedure to configure and enable Ethernet events. An Ethernet event is recorded (after

a user-specified time interval) when the switch-to-HAFM appliance communication link drops. To

configure and enable Ethernet events:

1. Minimize the Hardware View and return to the HAFM application.

2. At the HAFM or EWS main window, select the Monitor > Ethernet Event. The Configure Ethernet

Events dialog box is displayed (Figure 29).

Figure 29 Configure Ethernet Events dialog box

3. Click the Enable Ethernet Events check box. A check mark is displayed in the check box to

indicate Ethernet events are enabled.

4. Enter a value from 10 through 120 minutes in the Ethernet Timeout field.

5. Click OK to close the dialog box.