958-000290-003, March 2005)

Edge Switch 2/32 installation guide 79

6. Set the switch online:

a. At the View window, select Operations at the left side of the panel. The Operations panel

opens with the Switch Beacon page displayed.

b. At the Operations panel, click the Online State tab, then click Set Online. The message Your

operations changes have been successfully activated is displayed.

Configure network information

Verify that the type of LAN installation with the customer’s network administrator. If one switch is

installed on a dedicated LAN, network information (IP address, subnet mask, and gateway address)

does not require change. Go to ”Configure switch ports” on page 73.

If multiple switches are installed, or a public LAN segment is used, network information must be

changed to conform to the customer’s LAN addressing scheme. Perform one of the following:

• If network information was changed while performing”Configure switch network information” on

page 30, this procedure is not required. Go to ”Configure SNMP trap message recipients” on

page 80.

• If network information was not changed, perform this procedure.

Perform the following steps to change a switch IP address, subnet mask, or gateway address.

1. Click Configure at the left side of the window. The Configure window opens with the Ports page

displayed.

2. At the Configure window, click the Switch tab, then click the Network tab. The Switch page is

displayed with the Network tab selected (Figure 47).

Figure 47 Switch page—Network tab

a. At the IP Address field, enter the new value as specified by the customer’s network

administrator (default is 10.1.1.10, factory preset is 10.1.1.10).

b. At the Subnet Mask field, enter the new value as specified by the customer’s network

administrator (default is 255.0.0.0).

c. At the Gateway Address field, enter the new value as specified by the customer’s network

administrator (default is 0.0.0.0).