958-000290-003, March 2005)

Using the Embedded Web Server80

3. Click Activate to save the information. The following message box is displayed (Figure 48).

Figure 48 Network configuration changes activated

4. Update the address resolution protocol (ARP) table for the browser PC.

a. Select File > Exit to close the Embedded Web Server and browser applications. The

Windows desktop is displayed.

b. Select Start > Programs > Command Prompt. A disk operating system (DOS) window is

displayed.

c. Delete the switch’s old IP address from the ARP table. At the command (C:\) prompt, enter

arp —d xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the old IP address for the

switch.

d. Click close (X) at the upper right corner of the DOS window to close the window and return

to the Windows desktop.

5. At the PC, launch the browser application (Netscape Navigator

or Internet Explorer).

6. At the browser, enter the switch’s new IP address as the Internet URL. The Username and

Password Required dialog box is displayed.

7. Enter the default user name and password.

NOTE: The default user name is Administrator

and the default password is password. The

user name and password are case-sensitive.

8. Click OK. The Embedded Web Server interface opens with the View window displayed.

Configure SNMP trap message recipients

Perform this procedure to configure community names, write authorizations, and network addresses

for up to 6 SNMP trap message recipients per switch and up to 12 SNMP trap message recipients

per HAFM appliance. A trap recipient is a management workstation that receives notification

(through SNMP) if a switch event occurs.

To configure SNMP trap recipients:

1. Click Configure at the left side of the window. The Configure window opens with the Ports tab

displayed.