958-000290-003, March 2005)

Using the Embedded Web Server86

10.Change the switch IP address and restart the management appliance session as follows:

a. A grey square with a yellow exclamation mark appears adjacent to the icon representing the

reset switch, indicating switch is not communicating with the management appliance.

b. Delete the icon representing the reset switch. At the HAFM application, select Setup from the

Discover menu. The Discover Setup dialog box is displayed (Figure 53 on page 85).

c. Select (highlight) the entry representing the reset switch in the Available Addresses window

and click Remove.

d. At the Discover Setup dialog box, click OK. The switch is no longer defined to the

management appliance.

e. Change a switch’s IP address through the maintenance port at the rear of the switch. For

instructions, refer to ”Configure network information” on page 79.

f. Identify the switch to the HAFM application. For instructions, refer to ”Configure switch

identification” on page 74.

g. Switch-to-management appliance communication is restored and the procedure is complete.