FW 08.01.00 McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual (620-000155-220, November 2005)

3
3-82
McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual
Diagnostics
Select the McDATA Fabric 1.0 option if the switch is
fabric-attached only to other McDATA switches that are also
operating in McDATA Fabric 1.0 mode. Select the Open Fabric
1.0 option if the fabric contains OEM switches that are
open-fabric compliant.
c. Click the Activate button to save the selection and close the
dialog box.
Did configuring the management style solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
25
A loopback (wrap) plug is connected to the port and there is no
diagnostic test running. Is a loopback plug in the port receptacle?
YES NO
↓ Contact the next level of support. Exit MAP.
26
Remove the wrap plug from the port receptacle. If directed by the
customer, connect a fiber-optic jumper cable attaching a device to the
switch.
• If the port is operational and a device is not attached, both LEDs
adjacent to the port extinguish and the port state is No Light.
• If the port is operational and a device is attached, the green
LED illuminates, the amber LED extinguishes, and the port state
is Online.
Did removing the wrap plug solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
27
A port connection timed out because of an unresponsive device
(node) or an ISL connection was not allowed because of a security
violation (authorization failure reject). Check the port status and clean
the fiber-optic connectors on the cable.