FW 08.01.00 McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual (620-000155-220, November 2005)

3
3-100
McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual
Diagnostics
3. Select (highlight) the zone name to be modified (and later
deleted) at the Zone Library list, then select Copy Zone from
the Actions menu on the dialog box. The Copy Zone dialog
box displays.
4. Type the new zone name (specified by the customer) and
click OK. The new zone name appears in the Zone Library
list. The new zone contains the same members as the copied
zone.
5. Select (highlight) the new zone name and drag (holding the
left mouse button) the name to the Zones in Set list.
6. At the Zones in Set list, select (highlight) the zone name to be
deleted, then drag (holding the left mouse button) the name
off the Modify Zone Set dialog box.
7. At the Modify Zone Set dialog box, click Save Zone Set. The
zone set (with the new zone name) is saved and the dialog
box closes.
8. At the Zone Sets dialog box, select (highlight) the active zone
set name, then select Activate from the Actions menu on the
dialog box. The Activate Zone Set dialog box displays.
9. Click Start. The status message changes to Activate zone
set complete. Click Close to close the dialog box.
10.Click Close to close the Zone Sets dialog box and return to
the Zoning Set tab view with the modified active zone set.
Did the zone name change solve the problem and did both switches
join through the ISL to form a fabric?
NO YES
↓ The switches, associated ISL, and multiswitch fabric appear
operational.
Contact the next level of support.
15
The switch E_Port segmented because a build fabric protocol error
was detected.
a. Disconnect the fiber-optic jumper cable from the segmented
E_Port.
b. Reconnect the cable to the same port.