32 Installation Guide (AA-RSTZF-TE, November 2005)

Edge Switch 2/24 installation guide 45

3. Click OK to synchronize the date and time and close the Date and Time Synced dialog box, and

then click Activate to enable synchronization and close the Configure Date and Time dialog box.

Connecting cables to Fibre Channel ports

Perform this proceedure to connect devices to the Edge Switch:

1. Route single-mode or multimode fiber-optic cables (depending on the type of SFP pluggable

optic transceivers installed) from the desired devices to ports at the front of the Edge Switch.

2. Connect device cables to SFP transceivers.

3. Perform one of the following:

• If the Edge Switch is installed on a table or desk top, bundle and secure the Fibre Channel

cables as directed by the customer.

• If the Edge Switch is installed in an HP-supplied equipment rack, bundle Fibre Channel

cables from the Edge Switch and other equipment (groups of 16 maximum), and secure them

as directed by the customer.

4. Set the Edge Switch online.