32 Installation Guide (AA-RSTZF-TE, November 2005)

Using HAFM to configure the Edge Switch62

A check mark is displayed in the check box to indicate e-mail notification for the Edge Switch is

enabled, and the menu closes.

NOTE: Using HAFM, enable or disable e-mail event notification for each Edge Switch

individually.

Configuring and enabling call-home features

There are two call-home features available, and only one is installed when the HAFM application is

installed on the HAFM appliance. To learn more about configuring call-home features, see the HP

StorageWorks HA-Fabric Manager Appliance installation guide.

Configuring and enabling Ethernet events

Perform this procedure to configure and enable Ethernet events. An Ethernet event is recorded (after

a user-specified time interval) when the Edge Switch-to-HAFM appliance communication link drops.

1. Minimize the Hardware view and return to the HAFM application.

2. At the HAFM or HAFM Basic main window, select the Monitor > Ethernet Event.

The Configure Ethernet Events dialog box is displayed (Figure 30).

Figure 30 Configure Ethernet Events dialog box

3. Select the Enable Ethernet Events check box.

A check mark is displayed in the check box to indicate Ethernet events are enabled.

4. Enter a value from 10 through 120 minutes in the Ethernet Timeout box.

5. Click OK to close the dialog box.

Configuring, enabling, and testing call-home event notification

Telephone numbers and other information for the call-home feature are configured through the

Windows 2000 dial-up networking application. See ”Configuring and enabling call-home features”

on page 62 for configuration information. To configure, enable, and test call-home event

notification:

1. Minimize the Hardware view and return to the HAFM application.

2. At the HAFM or HAFM Basic main window, select the Event Notification and Call Home options

from the Monitor menu.