32 Installation Guide (AA-RSTZF-TE, November 2005)

Using the HAFM Basic interface80

Figure 46 Rx BB credit view

3. Click Default to select the default values.

A confirmation message is displayed.

4. Click OK to accept the default values.

NOTE: HP recommends that you use the default values. If they are not appropriate, you can

enter values in the RX BB Credit box.

NOTE: If you want to select another port, enter the port number in the Jump to Port box and

then click go.

5. Click OK to save the changes.

6. Place the port back online (see ”Setting the Edge Switch offline and online” on page 77).

Configuring Edge Switch identification

Perform this procedure to configure the Edge Switch name, description, location, and contact

person. The Name, Location, and Contact variables configured here correspond respectively to

the SNMP variables sysName, sysLocation, and sysContact. These variables are used by

SNMP management workstations when obtaining data from managed switches.

To configure the Edge Switch identification: