32 Installation Guide (AA-RSTZD-TE, July 2004)

Using the Embedded Web Server

112 Edge Switch 2/32 Installation Guide

Configure Network Information

Verify that the type of LAN installation with the customer’s network

administrator. If one switch is installed on a dedicated LAN, network information

(IP address, subnet mask, and gateway address) does not require change. Go to

“Configure Switch Ports” on page 102.

If multiple switches are installed, or a public LAN segment is used, network

information must be changed to conform to the customer’s LAN addressing

scheme. Perform one of the following:

■ If network information was changed while performing“Configure Switch

Network Information” on page 48, this procedure is not required. Go to

“Configure SNMP Trap Message Recipients” on page 115.

■ If network information was not changed, perform this procedure.

Perform the following steps to change a switch IP address, subnet mask, or

gateway address.

1. Click Configure at the left side of the window. The Configure window opens

with the Ports page displayed.

2. At the Configure window, click the Switch tab, then click the Network tab.

The Switch page displays with the Network tab selected (Figure 47).

Figure 47: Switch page—Network tab

a. At the IP Address field, enter the new value as specified by the

customer’s network administrator (default is 10.1.1.10, factory preset is

10.1.1.10).