32 Installation Guide (AA-RSTZD-TE, July 2004)

Using the Embedded Web Server

122 Edge Switch 2/32 Installation Guide

Figure 54: Domain Information dialog box

a. Enter 10.1.1.10 in the IP Address field and click OK. Entries at the

Discover Setup dialog box reflect the new IP address.

b. At the Discover Setup dialog box, click OK. Switch-to- management

appliance communication is restored and the procedure is complete.

10. Change the switch IP address and restart the management appliance session as

follows:

a. A grey square with a yellow exclamation mark appears adjacent to the

icon representing the reset switch, indicating switch is not communicating

with the management appliance.

b. Delete the icon representing the reset switch. At the HAFM application,

select Setup from the Discover menu. The Discover Setup dialog box

displays (Figure 53 on page 121).

c. Select (highlight) the entry representing the reset switch in the Available

Addresses window and click Remove.

d. At the Discover Setup dialog box, click OK. The switch is no longer

defined to the management appliance.

e. Change a switch’s IP address through the maintenance port at the rear of

the switch. For instructions, refer to “Configure Network Information” on

page 112.

f. Identify the switch to the HAFM application. For instructions, refer to

“Configure Switch Identification” on page 105.

g. Switch-to-management appliance communication is restored and the

procedure is complete.