32 Installation Guide (AA-RSTZD-TE, July 2004)

Installing and Configuring the Edge Switch 2/32

46 Edge Switch 2/32 Installation Guide

Install the Edge Switch on a Desktop

To install and configure the switch on a desktop:

1. Remove the backing from the four adhesive rubber pads and apply the pads to

the underside of the switch. Ensure that the pads are aligned with the scribed

circles at each corner.

2. Position the switch on a table or desktop as directed by the customer. Ensure:

■ Grounded AC electrical outlets are available.

■ Adequate ventilation is present.

■ Areas with excessive heat, dust, or moisture are avoided.

■ All planning considerations are met. Refer to the HP StorageWorks

HA-Fabric Manager User Guide.

3. Verify that all FRUs are installed as ordered.

4. Verify that the SFP optical transceivers are installed as required for your

installation.

5. Connect the U.S. or country-specific (optional) AC power cords to the right

(PS0) and left (PS1) receptacles at the rear of the chassis.

WARNING: An HP-supplied power cord is provided for each switch power

supply. To prevent electric shock when connecting the switch to primary facility

power, use only the supplied power cords, and ensure that the facility power

receptacle is the correct type, supplies the required voltage, and is properly

grounded.

6. Connect the remaining ends of the AC power cords to separate facility power

sources that provide single-phase, 120 to 240 volt alternating current (VAC).

This provides power redundancy.

7. Turn on the power. Two power switches are on the back of the unit. Turn on

both switches. The unit powers on and performs power-on self-tests (POSTs).

During POSTs:

a. The green power (PWR) LED on the front panel turns On.

b. The amber system error (ERR) LED on the front panel flashes

momentarily while the switch is tested.

c. The green LEDs associated with the Ethernet port flash momentarily

while the port is tested.