FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/32 Installation Guide (AA-RSTZD-TE, July 2004)

Installing and Configuring the Edge Switch 2/32
68 Edge Switch 2/32 Installation Guide
storage device vendor to determine if enabling Domain RSCNs will cause
problems with your HBA or storage products. Note that this option is required if
Enterprise Fabric Mode (optional SANtegrity binding feature) is enabled.
Suppress RSCNs on zone set activations
Fabric format domain register for state change notifications (RSCNs) are sent to
ports on the switch following any change to the fabric's active zone set. These
changes include activating and deactivating the zone set, or enabling and disabling
the default zone. When the Suppress RSCNs on zone set activations check box
is selected, fabric format RSCNs are not sent for zone changes to the attached
devices on the switch. Click the check box to remove or add a
check mark.
This option is enabled (check box not selected) by default. In most cases this
option should be enabled so that attached devices can receive notification of
zoning changes in the fabric. However, some HBAs may log out, then log back
into the fabric when they receive an RSCN, thereby disrupting Fibre Channel
traffic. Consult with your HBA and storage device vendor to determine if
disabling this option (and thereby enabling RSCN transmission) will cause
problems with your HBA or storage products.
Configure Fabric Operating Parameters
Use procedures in this section to set parameters on the switch for fabric operation
through the Configure Fabric Parameters dialog box. These operating
parameters are stored in NV-RAM on the switch.
1. The switch must be offline to change parameters in this dialog box. Ensure
that the switch is set offline. For instructions, see “Set the Switch Offline” on
page 62.
Caution: Setting the switch offline terminates all Fibre Channel connections.
2. At the Hardware View, choose Operating Parameters > Fabric Parameters
from the Element Manager window. The Configure Fabric Parameters dialog
box displays (Figure 20).