FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/32 Service Manual (AA-RS2GD-TE, July 2004)

Messages
214 Edge Switch 2/24 Service Manual
Cannot install firmware
to a switch with a failed
CTP card.
Firmware cannot be
installed on a switch with
a defective CTP card.
Note that the CTP card is
not a FRU. If it fails, the
switch must be replaced.
After replacement, retry the
firmware install to the
switch.
Cannot perform this
operation while the
switch is offline.
This operation cannot
take place while the
switch is offline.
Configure the switch offline
through the Set Online
State dialog box then retry
the operation.
Cannot retrieve current
SNMP configuration.
The current SNMP
configuration cannot be
retrieved. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve
diagnostics results.
Diagnostics results
cannot be retrieved. The
link is down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve
information for port.
Information for the port
cannot be retrieved. The
link is down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve port
configuration.
Port configuration
cannot be retrieved. The
link is down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve port
information.
Port information cannot
be retrieved. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve port
statistics.
Port statistics cannot be
retrieved. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve switch
date and time.
Switch date and time
cannot be retrieved. The
link is down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot retrieve switch
state.
Switch state cannot be
retrieved. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot run diagnostics
on a port that is failed.
Port diagnostics cannot
be performed on a port
that has failed.
Run diagnostics only on an
operational port.
Table 25:
Edge Switch 2/32 Element Manager Messages (Continued)
Message Description Action