FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/32 Service Manual (AA-RS2GD-TE, July 2004)

Messages
216 Edge Switch 2/24 Service Manual
Cannot set Fibre
Channel parameters.
Fibre Channel
parameters cannot be
set. The link is down or
busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot set switch date
and time.
Switch date and time
cannot be set. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot set switch state. Switch state cannot be
set. The link is down or
busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot set write
authorization without
defining a community
name.
A community name was
not defined in the
Configure SNMP dialog
box for the write
authorization selected.
Provide a name in the
name field where write
authorization is checked.
Cannot start data
collection.
Data collection cannot
be started. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot start firmware
install while CTP
synchronization is in
progress.
CTP synchronization is
in progress while you
are attempting to install
firmware.
Wait for the CTP
synchronization to
complete before starting
the firmware install.
Cannot start port
diagnostics.
Port diagnostics cannot
be started. The link is
down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot swap an
uninstalled port.
A port swap cannot be
performed when the port
is not installed.
Perform a swap only on a
port that is installed.
Click OK to remove all
contents from log.
Requesting confirmation
that you want all
contents removed from
the log.
Click OK to continue or
Cancel to cancel the
operation.
Continuing may
overwrite host
programming.
Continue?
Configurations sent from
the host may be
overwritten by HAFM.
Continuing will activate the
current configuration,
which may have been
configured by a FICON
host.
Table 25:
Edge Switch 2/32 Element Manager Messages (Continued)
Message Description Action