HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
133Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Enable Access to the Hosts at the Initiator Site
I The initiator hosts must have access to the units. Enable access with the following command:
SET UnitName ENABLE_ACCESS_PATH=InitiatorHostConnectionNamex,
InitiatorHostConnectionNamey
Example: set UnitName enable_access_path=HostA1,HostA2
Repeat this step for each unit.
Verify the Disks
I Verify that disks are present by issuing the following commands:
cfgmgr –v
lsdev –Cc disk
The cfgmgr command configures hdisks for all LUNs that your system can access on the
storage arrays.
The output of the lsdev command should be similar to that shown in
Example Display 45.
Example Display 45
hdisk0 Available 10-60-00-6,0 16 Bit LVD SCSI Disk Drive
hdisk1 Available 20-58-00-8,0 DEC HSG80 Command Console LUN
hdisk2 Available 20-58-00-8,7 DEC HSG80 RAID Array
In this example:
hdisk0 represents the internal hard drive of your AIX host.
hdisk1 represents the Command Console LUN (CCL).
hdisk2 represents a single unit or LUN (LUN 7 as denoted by the last number in the line
20-58-00-8,7).
Configure the SWCC Agent (Optional)
I The SWCC Agent may now be installed and configured. Refer to the HP StorageWorks
HSG80 ACS Solution Software Version 8.7 for IBM AIX Installation and Configuration Guide
for installation instructions.
Additional Setup
I You may now configure volume groups, logical volumes, and file systems on the storage
arrays using normal AIX procedures.
Your AIX host is now configured to use DRM. Repeat this procedure for each AIX host
present at the initiator site. After configuring the initiator site hosts, go to the section titled
“Additional Host Configuration,” on page 144.