HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
134 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Microsoft Windows NT and Windows 2000
Before beginning this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Ensure that the hosts are not connected to the Fibre Channel switches at any point during this
procedure.
Install the HBAs
I You must install at least two HBAs in each host system. HBAs must be installed in pairs.
Record the HBA WWID for use later in this section. Refer to the Compaq StorageWorks
64-Bit PCI-to-Fibre Channel Host Bus Adapter User Guide for installation instructions. The
user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs until instructed to do so. The driver is
installed in the following step.
Install the HBA Driver
I Use Device Manager to install the HBA driver. For updated driver version information, refer to
the DRM Release Notes.
Install Fibre Channel Software
I Install the HP Fibre Channel software on the host. For updated Fibre Channel software version
information, refer to the DRM Release Notes.
Install Multipath Software
Secure Path must be installed on the host at this point. For installation instructions, refer to the
current version of the HP StorageWorks Secure Path Version for Microsoft Windows
Installation and Reference Guide.
I 1. Verify that the Secure Path Agent is installed by going to Administrative Tools and
selecting Services. The Secure Path Agent must be set for automatic setup and started.
I 2. Use the Secure Path Agent Configuration utility to grant access to the client at both the
initiator and target sites. To do this, follow these menus:
Start > Programs > Secure Path > Secure Path Cfg.
I 3. You can set the password and allow client access via the Secure Path Agent Configuration
utility.
Note: HP recommends that you set both the fully qualified and unqualified DNS names as
valid, authorized clients.
I 4. Restart the Secure Path Agent service for changes to take effect.